AUTOSCOPE MT-900 - Car diagnosis, Oscilloscope, Multi-meter, Ignition test

Description

Autoscope MT-900
(Oscilloscope+Multimeter+Ground test+Ignition test)
Vertical scale:25mV/DIV ~ 100V/DIV
Horizontal scale: 500uS/DIV ~ 10S/DIV
Mode: Scope, DC volt, Frequency, duty, Ground test, Whistles mode, Ignition mode
Channel:1 CH
Max. measuring voltage: DC200V
Measuring frequency: 0.5 Hz ~
약
100KHz
Measuring duty: 0.1 % ~ 99.9 %
Display: STN, mono (128x64 Pixel)
Battery: 3.7V Li-Po rechargeable, USB port
Hours of use: Approx. 50 hours (When back-light OFF)
Size: 154 x 77 x 32 mm
Weight: 200g
Component: Main tester, Manual, BNC cable, Probe 2EA, Alligator clip, USB cable
Automatic scope mode
-Wire, Signal, ABS sensor, Cam sensor, Crank angle sensor, Oxygen sensor, Air flow sensor, ECU check etc.
You can switch to scope mode by pressing and holding the hold button at the scope mode.
The time sets to 1 sec and can be conveniently used when measuring oxygen sensors which has long waveform
Voltage mode
- Display voltage
Possible to change auto mode to manual mode by pressing
and holding the move button
Possible to initialize Min. and Max. by pressing +button
Frequency
–
Duty mode
- IMV test, common rail test, LPG carburetor adjustment
Ignition mode
-Waveform diagnosis only when you put it on the coil
-Coil , Plug, Compression and Coil short circuit test
Ground mode
- Check Level 1~10 (1~2:normal, 3~4: check required 5~: bad symptoms, if it reaches 10 : significant problems occurs such as start-up malfunction, engine stops, vibration, low fuel-efficiency and headlight shaking.
Whistle mode
–
Display voltage when buzzer rings
ex) ~2.49V: Silence, 2.5~4.1V Beep, Beep, 4.11~9.2V: Beep-Beep, 9.21V~: Beep~~~~